Allen-Bradley 2711P-T6M5D HMI Terminal – Obsolete PanelView Plus 600 Spare Part

Technical Dossier

Product Details And Specifications

Allen-Bradley 2711P-T6M5D HMI Terminal – Obsolete PanelView Plus 600 Spare Part

RFQ support for obsolete parts: Send the model number, required quantity and destination so DriveKNMS can confirm sourcing options before quotation.

Technical Specifications

Solving the Discontinued Hardware Crisis

The migration path is not straightforward. FactoryTalk View ME application files (.mer) developed for the PanelView Plus 600 series are not directly portable to newer PanelView 800 or PanelView 5000 platforms without screen resolution rework, tag remapping, and in many cases, communication driver reconfiguration. For plants running SLC 500 or legacy MicroLogix controllers alongside this terminal, the interdependency runs even deeper — the HMI, the PLC, and the network topology were designed as a system. Replacing one component forces a review of all others.

The 2711P-T6M5D is commonly found in systems paired with Allen-Bradley SLC 5/05 processors, CompactLogix L3x series controllers, and legacy Rockwell PanelBuilder 32 or FactoryTalk View ME v5.x application environments. Its DH-485 and RS-232 communication ports remain the native interface for a large installed base of equipment that has no cost-effective modern equivalent.

Condition & Reliability Assurance

Sourcing obsolete hardware from the secondary market carries real risk. DriveKNMS applies a 5-step inspection protocol to every 2711P-T6M5D unit before it is offered for sale:

• Step 1 – Electrolytic Capacitor Assessment: Aging capacitors are the primary failure mode in HMI units of this generation. Each board is inspected for bulging, leakage, and ESR deviation. Units with degraded capacitors are either recapped or rejected.
• Step 2 – Firmware Version Verification: The installed firmware version is confirmed and documented. Units are checked for known firmware-related display or communication faults.
• Step 3 – Pin and Connector Inspection: All communication ports (DH-485, RS-232) and power connectors are inspected for corrosion, pin deformation, and contact resistance.
• Step 4 – Display and Backlight Test: The grayscale display is powered and tested for dead pixels, backlight uniformity, and contrast stability across the full screen area.
• Step 5 – Functional Communication Test: Where test equipment permits, the unit is verified to establish communication on its native protocol before packaging.

Units are classified as New (factory-sealed), Refurbished (inspected and restored to functional specification), or Tested-Used (functional, cosmetic wear). Condition is disclosed in full at the time of quotation.

Key Features for System Maintenance

How do I know the unit is genuine and not counterfeit?
All units are sourced through verified industrial surplus channels. Serial numbers are checked against known production ranges. Physical markings, board construction, and component dating are reviewed as part of the inspection process. We do not sell units that fail authenticity checks.

Should I buy more than one unit?
For facilities with multiple lines running the same HMI model, holding two to three spare units is standard practice. The 2711P-T6M5D is no longer manufactured, and secondary market availability will continue to decline. Procurement now, while RFQ-reviewed sourcing status exists, is a lower-cost decision than emergency sourcing during a production stoppage.

Can you supply the FactoryTalk View ME software license as well?
Software licensing is managed separately through Rockwell Automation's official channels. DriveKNMS supplies hardware only. We recommend confirming your existing license status with your Rockwell distributor before installation.