Fireye 95UVS2-1 Flame Scanner – Obsolete UV Flame Detector Spare Part

Technical Dossier

Product Details And Specifications

Fireye 95UVS2-1 Flame Scanner – Obsolete UV Flame Detector Spare Part

RFQ support for obsolete parts: Send the model number, required quantity and destination so DriveKNMS can confirm sourcing options before quotation.

Technical Specifications

Note: Electrical parameters such as supply voltage and output signal type vary by installation configuration. Consult your original system documentation. DriveKNMS does not publish unverified specifications.

Solving the Discontinued Hardware Crisis

The Fireye 95UVS2-1 was designed for a generation of burner management systems that prioritized deterministic, hardwired safety logic over software-defined control. That design philosophy is precisely why these systems remain in service decades after installation — they are reliable, well-understood by maintenance teams, and carry a safety validation history that a replacement system would need years to replicate.

Condition & Reliability Assurance

DriveKNMS applies a five-stage quality process to all obsolete flame scanner units before dispatch:

• Visual and mechanical inspection: Housing integrity, lens condition, and connector pin examination for corrosion, oxidation, or mechanical deformation.
• Electrolytic capacitor assessment: Aging capacitors are a primary failure mode in stored electronics. Units are evaluated for capacitor condition; where degradation is identified, this is disclosed to the buyer.
• Firmware and version verification: Where applicable, firmware revision is confirmed against Fireye documentation to ensure compatibility with the target programmer series.
• Functional bench test: UV response is verified using a controlled UV source prior to packaging.
• Packaging for long-term storage: Units are packed in anti-static, moisture-barrier packaging suitable for extended shelf storage in a controlled environment.

Key Features for System Maintenance

• Drop-in replacement: The 95UVS2-1 installs directly into existing Fireye programmer mounts without mechanical modification.
• No reprogramming required: The scanner interfaces with the existing programmer via the original hardwired signal path. There is no firmware to configure, no IP address to assign, no commissioning software required.
• Avoids engineering re-scope: Substituting a modern flame detection system requires P&ID revision, safety function re-validation under IEC 61511, and in many jurisdictions, third-party audit. A like-for-like 95UVS2-1 replacement requires none of this.
• Maintains existing safety certification baseline: The burner management system's safety integrity level (SIL) assessment remains valid when the replacement component is identical to the original design specification.
• Supports planned maintenance scheduling: With a spare unit on hand, scanner replacement can be scheduled during a planned outage rather than executed as an emergency repair.

How do I confirm the unit is genuine Fireye manufacture?
All units supplied by DriveKNMS carry original Fireye part markings. Upon request, we provide high-resolution photographs of the unit label, date codes, and connector assembly prior to shipment. Buyers are encouraged to cross-reference against Fireye's published part documentation.

Should I purchase more than one unit?
For any system where the 95UVS2-1 is a single point of failure — which is the case in most single-burner installations — holding a minimum of one spare unit on-site is standard maintenance practice. For multi-burner installations or facilities without rapid procurement capability, two to three units is a defensible inventory position. The cost of storage is trivial relative to the cost of an unplanned outage.

Can DriveKNMS source other Fireye obsolete parts?
Yes. DriveKNMS specializes in hard-to-find and discontinued industrial automation components across multiple brands. Contact us with your part number for a sourcing inquiry.