GE DS200SDCIG2AFB Turbine Control Board – Obsolete Mark V Spare Part
General Electric DS200SDCIG2AFB is listed for Mark V RFQ review. Confirm quantity, condition and destination before quotation.
Model: DS200SVAAG1A DS200SVAAG1ACB
Product Overview
Commercial availability is handled through direct RFQ, model verification and export-oriented follow-up rather than public cart checkout.
Datasheet Preview
Use attached product manuals when available. If the manual is not public yet, request the full file directly through RFQ.
Commercial Path
Product pages on DRIVEKNMS are designed to verify model, brand and series first, then move the buyer into one clean quotation path.
Technical Dossier
The GE DS200 series is a family of printed circuit board assemblies developed by GE (General Electric) for use within the Mark V, Mark VI, and associated turbine control platforms. These modules are deployed across critical heavy-industry installations worldwide, including petrochemical refineries, nuclear power stations, combined-cycle gas turbine plants, and offshore oil and gas facilities. The DS200 designation covers a broad range of I/O, signal conditioning, power supply, communication, and processor boards that form the backbone of GE's distributed control architecture. Due to the long operational lifecycles typical of power generation and process industries — often 20 to 30 years per installation — DS200 components remain in active demand for maintenance, repair, and overhaul (MRO) programs well beyond their original production runs.
The DS200 series emerged as part of GE's Mark V turbine control system, introduced in the late 1980s and widely deployed through the 1990s. Mark V represented a significant architectural shift from relay-based and early solid-state control toward fully digital, redundant TMR (Triple Modular Redundancy) control. DS200 boards were designed to interface with thermocouples, RTDs, 4–20 mA analog loops, discrete I/O, and high-speed pulse inputs from turbine speed probes.
With the introduction of the Mark VI platform in the early 2000s, GE transitioned to a more modular, Ethernet-based I/O architecture using the IONET and ARCNET communication buses. Many DS200 boards were carried forward into Mark VI configurations with revised firmware and board-level modifications, reflected in suffix changes (e.g., from DS200SVAAG1A to DS200SVAAG1ACB). The Mark VIe further extended this lineage with IEC 61850 compatibility and fiber-optic I/O, but a large installed base of DS200-era hardware remains in service, creating sustained demand for exact-match replacement boards.
Compatibility between board revisions is not always guaranteed. Suffix letters (A, B, C, etc.) and firmware revision codes must be matched precisely when replacing boards in TMR configurations to avoid control system faults. This makes sourcing from a specialist supplier with revision-level inventory tracking essential.
Voltage Attenuator / Signal Conditioning
Analog I/O Modules
Digital I/O Modules
Processor / Controller Boards
Communication & Network Adapters
Power Supply Modules
DS200 boards present specific test challenges due to their mixed analog/digital architecture, high-impedance signal paths, and in some cases, proprietary ASIC components that cannot be tested with generic ATE equipment.
DriveKNMS applies the following test protocol to all DS200 units prior to dispatch:
Continue The Model Path
Move from this exact model into the matching system hub, brand archive, model-family archive or lifecycle sourcing route before sending a final RFQ list.